The good news is that we ended up going 4-1 with the deck at Mythic, bringing our overall record to 15-1 across Diamond and Mythic, which is pretty absurd for a $35 deck
3D printing settings we used: Layer height 0.2 mm No Supports 0 bottom layers Infill 9% Triangles (because of the low infill we set a single solid layer to print on the layer where the type symbol starts printing because it wasnt bridging it well enough
However, after a feeling that some sets were so flooded with serialized cards that they werent as special anymore, WotC changed tactics and moved to one featured card instead
At 1% pull rate from Collector Boosters versus 9% for the standard showcase, you are roughly nine times less likely to pull #400 than #390 out of the same pack
MtG The List Uncommon Manglehorn AKH-175 [Amonkhet] MtG The List Uncommon Manglehorn AKH-175 [Amonkhet] OUT OF STOCK Estimated ship date NOTIFY ME WHEN AVAILABLE Email address submitted
3 Likes Home Categories Guidelines Terms of Service Privacy Policy Powered by Discourse, best viewed with JavaScript enabled
