Tork Craft Annular Hole Cutter HSS 31 X 30mm Weld Shank 19.05mm TC08424 Easy retrofit for existing GU10

Easy retrofit for existing GU10 fixtures

rubber-face design for gentle clamping

From pressing

shock-absorbing rubber casing

you have complete control over your lighting

Tork Craft Annular Hole Cutter HSS 31 X 30mm Weld Shank 19.05mm TC08424 Easy retrofit for existing GU10Annular Cutters 30mm Annular Cutter: 31 mm One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these concerns is