PowerBox PowerBus to Bus Adapter 9210 FUEL reactive energy

reactive energy

90 Volts •Two independent electronic switches •Two volt controller ( in 4 steps ) for each battery NEW •Two Low voltage memory for both batteries NEW •SET button for On / Off switching protection •LED indicators for both power circuits •Operating voltage range 4

For servo connector pins you will always use the smaller set of teeth

accepts balloon filler for forming fillets

0V Current drain Power-on state 18mA Supported telemetry systems S-BUS 2 Dimensions 33 x 10 x 3 mm Weight 6g Temperature range -30°C to +75°C EMV approval EN 55014-1:2006 + A1:2009 CE approval 2004/108/EG

PowerBox PowerBus to Bus Adapter 9210 FUEL reactive energyPowerBox PowerBus to Bus Adapter 9210 The PowerBus to BUS Adapter is designed for use with servos which are fitted with an integral bus decoder. At present these are Futaba S Bus servos. When these servos are used, the channel assignment is programmed directly at the servo. The PowerBus to Bus Adapter does not feature a decoder, but nevertheless all the outputs are protected against short circuits both in the signal wire and the power supply wires, as