Disco on a Stick by Blamm PFA 2 or older please use

2 or older please use some sort of m3 plastic washer when mounting the PCB

Hall Effect Endstop board for X and Y axes

These should not need a new flash

Centering Shaft ~165mm from outer Frame to Axel end on each side

there was an issue and i have since updated the repo with a known good board if you have any problems please contact me on discord

Disco on a Stick by Blamm PFA 2 or older please useThe original Disco on a Stick is a chainable 5V RGB bar, to be used with high quality RGB LED's to give the illusion of a Disco in your Voron. Great when making photo's of your prints, or want to see the colors how they will look in the outside world. These are meant for 250 and up sized printers. 270mm length More info can be found here: Disco Sticks